欢迎进入北京龙盛门业有限公司网站
全国服务热线
13940183063
行业新闻
「张家口快速门」涡轮硬质快速门运行过程中需
时间: 2019-07-01 12:30 浏览次数:
涡轮硬质快速门安装的方法,硬质快速门抗风等级,快速门抗风筋「张家口快速门」涡轮硬质快速门运行过程中需要注意事项



「张家口快速门」涡轮硬质快速门运行过程中需要注意事项


Cautions to be noticed in the operation of "Zhangjiakou Fast Gate" Turbine Hard Fast Gate


 

1,sej变频器正常应用运转中禁止将马达机组投入或切离,不然可能会导致sej变频器过电流跳脱,甚至快速门的变频器主板回路烧毁。


1. It is forbidden to put motor units into operation or cut off during normal operation of sej frequency converter. Otherwise, it may lead to over-current jump of sej frequency converter and even burnout of main board circuit of fast-door frequency converter.

 

2.硬质快速门的变频器正常工作送电过程中不要取下前盖,以防止漏电受伤和损坏电子元件。


2. Do not remove the front cover during the normal operation of the hard fast-door converter to prevent leakage injury and damage to electronic components.


3.在开启过程中发现故障后,重新再启动硬质门的功能时,伺服电机在调整后会自动重新启动,不要太过于靠近机器,以免发生事故。



3. When the function of hard door is restarted after the fault is found in the opening process, the servo motor will restart automatically after adjustment. Do not be too close to the machine to avoid accidents.
 

4.硬质快速门的散热座和刹车电阻等发热元件不要触摸,会有余温,谨防烫伤。


4. Hard fast door heat sink and brake resistance and other heating elements do not touch, there will be residual temperature, beware of scald.



 

北京硬质快速门厂家
 


5.涡轮硬质快速门变频器可以设置电机对门帘的运行从低速到高速运转,设置的局限应该在龙盛门业说明书的标明的速度允许局限,【保定堆积门】快速门变频器出现ER13是怎么回事 ,避免发现错误信息提示。


5. Turbine hard fast door converter can set motor to run the door curtain from low speed to high speed. The limitation of setting should be the speed allowable limitation indicated in Longsheng Gate Industry Instructions. [Baoding Stack Gate] What is the ER13 problem in fast door converter, so as to avoid finding wrong information.



「张家口快速门」涡轮硬质快速门运行过程中需要注意事项


Cautions to be noticed in the operation of "Zhangjiakou Fast Gate" Turbine Hard Fast Gate


6.涡轮硬质快速门在工作运转中不要去打开电路板上检查信号,避免发生不可预估的危险。


6. Turbine hard fast door in operation should not open the circuit board to check the signal, to avoid unpredictable danger.
 

7.快速门的变频器出厂时由车间调试过底子设置,现场安装的时候,安装师傅也根据现场情况作了适当调整,8.快速门变频器超过50赫兹以上的频率工作时,应该顾虑到振动、噪音、电机轴承及机械装置的元素,「北京快速门」,设置运行的速度局限不能过大。


8. When the fast-door converter works at frequencies above 50 Hz, it should take into account the elements of vibration, noise, motor bearings and mechanical devices. The speed limit of Beijing fast-door should not be too large.

 

10.硬质门的减速器上接纳电子编码器定位时,「张家口快速门」,可通过拉开手刹,然后手动把门体推起,通电后快速门把手刹复位可正常应用。手动调节门体,来电需要重新定位后方能应用。


10. When the electronic encoder is positioned on the reducer of the hard door, the "Zhangjiakou Express Door" can be used normally by pulling the hand brake and then pushing the door manually. After power is turned on, the handle brake of the fast door can be reset. Manual adjustment of the door body, calls need to be re-positioned before they can be applied.



 

Copyright © 北京龙盛门业有限公司 版权所有 辽ICP备:备案中···
全国服务电话:13940183063   售后服务:024-31081023
公司地址:北京市怀柔区宝山镇

百度地图 - 网站地图